Installation and Operation Guide

Page 15
Filters
For this appliance to function eectively, regular maintenance is a must.
The function of the lter is to absorb the grease particles emitted during cooking.
Blocked lters and heavy oil deposits restrict airow and may cause the motor to overheat and become a re
hazard.
Filters should be cleaned every 3-6 weeks or after 40 hours of use.
Disconnect the electrical connection before any maintenance or cleaning processes are carried out.
In ceiling-mounted rangehoods, the doors or glass must be opened before accessing the lters.
To remove the lter, press ‘Catch A’ towards the rear of the rangehood (removing the pins from the front
guide), ease down slightly and remove. To replace, perform the same operation but in reverse, see gure 1.
If your model is equipped with the Balanced Aspiration System periodical cleaning is required.
The Balanced Aspiration plate can be removed by taking out the 6 screws shown in gure 2. Please make
sure it is fully dry before installing back to the rangehood.
WARNING
Always switch o and disconnect power to the rangehood before cleaning. The manufacturer is
exonerated from all responsibility in the event of re due to poor maintenance of the lters and
rangehood.
Cleaning and user maintenance shall not be made by children without supervision.
6. Cleaning and Maintenance
Latch A
Catch A
Figure 2Figure 1