Installation Guide

Page 13
Figure 4
Flat Roof Installation
Flat roof mounting using optional mounting ange*.
PED
Engage locking
screws in holes
Seal 3 holes in
stepped surface
Seal between mounting
ange and cover
Up-stand and
capping
Power supply cord
passing through
pipe slots
NOTE: Cut 150mm PVC
stormwater pipe to length and
reslot ducting end. Ensure that fan
end locking holes remain
200mm Flexible
Ducting
Seal top edge of ange
50
Protrusion of pipe above
mounting ange
Bond ange to pipe using
silicone, urethane or type ‘N’
PVC solvent cement
Optional mounting ange
P40113MF*
Roof Cladding
1600
motor
*Optional wall mounting ange (P40113MF) is available
from Schweigen, please contact 1300 829 066.
Hanging Bracket P1107*
NOTE: Hanging bracket is required
4. Installation
IMPORANT
It is a requirement to use the hanging bracket for all wall mount installations.
Please refer to the manual for more information.