Installation Guide

Page 16

Figure 10 Roof mount option

Twin Motor Installation (suitable for rangehoods with one 200mm outlets)

Where two motors are to be used and there is only one 200mm outlet, follow the below methods for each

motor then join into the “Y” piece prior to joining ducting to the canopy / rangehood. Refer gure 10.

The two motors can be wired by one of the following methods:

• Wired into one plug by an electrician

• A double adaptor plugged into the lead from the canopy / rangehood

• A double GPO powered from the canopy

Cover

Try to keep length of

exible ducting as even

as possible other wise

motors will draw air o

each other

Ensure exible ducting

is fully extended and as

short as possible. Use

smooth owing curves for

maximum air ow. Remove

excess ducting by trimming

to length.

‘Y’ Junction for Twin 900/1600

Fan Installation

• 200 x 200 x 200mm

• Multi-t Y joint to be used with all

twin 1600 motor installation where

the rangehood has only one 200mm

opening

If multi-t Y joint is supplied

you will need to cut ducting to

length.

1600 motor

Z: Minimum distance

between the two fans

is 600mm.

4. Installation