RANGEHOOD & INSTALLATION GUIDE UM4220-12S Revision V3.2 HOME APPLIANCES www.schweigen.com.
Index 1. Welcome _____________________________________________________________________________________________________ 3 2.
1. Welcome Thank you for purchasing your new Schweigen rangehood. To get the maximum output from this unit, please read through this guide before use. The guide contains important information on the use and maintenance of the unit, as well as important safety notes. This will ensure your personal safety and the lasting value of your rangehood. We trust that you will enjoy your new Schweigen rangehood. Please always retain your proof of purchase to aid in any warranty queries.
2. Your Safety WARNING Please read this section thoroughly before attempting to operate the appliance. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised. DO NOT INSTALL THIS APPLIANCE IF YOU FIND IT DAMAGED. If this product is installed damaged, neither the supplier, nor the retailer, will be responsible for the costs associated with the repair, replacement, removal or re-installation of the appliances. 1.
2. Your Safety Before Installation 1. We recommend this appliance be installed or repaired by a qualified Schweigen Home Appliances technician. 2. Please see our website www.schweigen.com.au for recommended installers. 3. It is dangerous to modify any part of this appliance. Modification of any kind, will immediately void the warranty. 4. The manufacturer declines all responsibility in case of failure to adopt proper safety measures. 5.
2. Your Safety Product Use This product is designed for household use and should not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. When frying with a gas flame, take particular care not to allow the oil or grease in the pan to catch fire. (Flambé) Maintenance and Service The rangehood surface should be cleaned with soft cloth and non-corrosive detergent. Do not leave the rangehood wet after cleaning or use, please keep rangehood dry.
3. Tips & Suggestions The Rangehood has one mode of operation: Air extraction: The air is drawn in and cleaned by the grease filters and directed outside. Please check the cleaning and maintenance section for the filters’ cleaning periods. For Users 1. Do not leave the frying pan or fryer unattended, as the oil could overheat and catch fire. 2. Never flambé any foods beneath the rangehood. The flames could cause a fire. 3.
4. Description Main Rangehood 1 For use with Isodrive motor system 2 Male Plug (Main Power 240V) 3 2 X Main 200mm Outlet 4 3 x 150mm Outlets (optional only)* 5 Remote 6 Reducer (For Isodrive 650 only) 7 Lamp (For GU10 fittings, please twist to remove) 8 Filter 9 LED Indicator Panel 10 Extraction Sheets 1 2 3 4 POWER * Only to be used as an alternative, please note using the 5 8 6 7 9 10 150mm outlets can reduce airflow.
5. Operation Schweigen silent rangehoods are recognised for their silent operation. Although this holds true for all of our rangehoods with external motors, one must note that the rangehoods are silent when they are used for regular cooking on the lower fan setting. Therefore, you will only hear the movement of air. Remote Control and Buttons: NOTE: There is no control button on the hood. The hood can only be operated by remote control. On/Off: Use this button for activating and deactivating the motor.
6. Cleaning & Maintenance WARNING Always switch off and disconnect power before cleaning. Surfaces Wash with warm soapy water and a soft sponge. Never use abrasive detergent, scouring pads, steel wool or solvents on any part of this appliance, Always make sure to dry the appliance after cleaning and never leave wet, as this will cause irreparable damage. Filters • For this appliance to function effectively, regular maintenance is a must.
6. Cleaning & Maintenance WARNING • If the grease filters are very dirty, the motor will extract only a small quantity of air, which reduces its efficiency; • The grease deposits that build up on the filter are highly flammable and COULD EASILY CATCH FIRE. • The manufacturer is exonerated from all responsibility in the event of fire due to poor maintenance of the grease filters. Cleaning the Interior Clean the interior of the rangehood with a damp cloth and a neutral detergent or denatured alcohol.
6. Cleaning & Maintenance Replacing the GU10 Light Bulb DANGER Always switch off and disconnect power before replacing the lights. Failure to do so may cause serious injury. Please be aware that the light bulb will retain heat for a short period of time after being switched off. Step 1 Remove the filters from the rangehood. Step 2 Gently push light holder down, turn light bulb anti-clockwise, pull the light bulb down and remove it from the light holder. Step 3 Gently push light holder down.
7. Installation DANGER Always switch off and disconnect power before installing the rangehood. Failure to do so may cause serious injury. Mounting Laws and Regulations The minimum distance between the bench top and the lowest part of the rangehood should not be less than: For indoor kitchen area: 1200mm (All cooktop types) There is no maximum height. However, any height more than 1800mm above the cooktop may reduce the effectiveness of the air extraction rate.
7. Installation Ceiling Cassette Installation Guide • To install the rangehood to the ceiling, there needs to be a section on the ceiling that corresponds to the sizes given in the technical drawing with support for the rangehood frame. • Open the split-extraction sheet of the device and remove the filter before installing • The external motor system with the rangehood can be connected at this stage or after the rangehood has been secured.
7. Installation Optional Bulk Head Installation Guide • To install the rangehood into a bulk head, there needs to be a bulk head made that corresponds to the sizes given in the technical drawing with support for the rangehood. • Open the split-extraction sheet of the device and remove the filter before installing. • Install threaded rods onto the beam and drill holes at the four corners on the rangehood, adjust the nuts to level the unit. • Connect the external motor system with the rangehood.
7. Installation Single IsoDrive Motor Installation 1 2 3 1 Isodrive Motor 2 Roof Seal Kit (Dektite)* 3 Support Straps* 4 Attach Flexi Duct to Bell-Mouth Adaptor using aluminium foil tape or cable tie etc. Please DO NOT rip the ducting. 5 Motor Power Lead (Male Plug) 6 Rangehood to Motor Lead (Female Plug) 7 Multi-fit Y Joint, cut to 200 x 200 x 200mm 8 Main Power Lead (Male Plug) 9 Flexi Ducting must be pulled taut. DO NOT crush or kink the ducting.
TwIn MoToR InSTALLATIon 7. Installation For Cassette / Ceiling Rangehoods Overview Revision V2 WARNING All electrical wiring (for connection from motor to rangehood) should be kept inside Warning the roof space. All electrical wiring should be kept inside the roof space.
8. Maintenance Condensation Information The induction cooktop is designed to provide rapid heating, improved thermal efficiency and greater heat consistency. For some customers with an induction cooktop, condensation can form on their rangehood filters while using their cooktop. The induction cooktops’ heat source is contained in the conductive base of the pot.
8. Maintenance User advice to avoid condensation in the rangehood: • The rangehood should be switched on approx. 10 minutes prior to cooking and the delay shut down timer set after cooking has stopped in order to clear the fumes held in the flue. These steps will help clear the flue out fully. • Do not cook at full power straight away, i.e. start on low or medium power for a while so that the steel in the rangehood can warm up. • Filters must be kept clean.
Check motor switch. Please ensure that there is power to the rangehood and the rangehood is switched on. Rangehood does not work X X Light does not work X Model Feeding Voltage Lamp Power — Halogen (W) Lamp Power — LED (W) Page 20 Loud noise from the rangehood Technical Specifications UM4220-12S 220-240V 50Hz 6 x 35W (supplied) 6 x 1.
8. Maintenance Calling the Technical Assistance Service Hotline In the event that the failure is not due to the faults mentioned in Trouble Shooting, contact the Technical Service 1300 829 066. A service request will require the following information: • The purchase date • The rangehood model and motor type (eg.
9.
10. Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale.
HOME APPLIANCES Distributed by: Unit 102/45 Gilby Road, Mt Waverley 3149 Victoria. 1300 881 693 (EST) www.schweigen.com.