Owner's manual

39
NOTICE:TopreventdamagetothenishofthemachineorConsole,donotcleanwithapetroleumbasedsolvent.
Do not apply too much moisture to the Console.
Adjusting the Belt Tension
If the walking belt starts to slip during use, it is necessary to adjust the tension. Your treadmill has tension bolts at the rear
of the treadmill.
1. Before you adjust the belt tension, start the treadmill by pushing the START button.
Be sure not to touch the walking belt or step on the power cord. Keep bystanders and children away from
the product you are servicing at all times.
2. Usea6mmhexkeytoturntherightandleftbeltadjustmentboltsclockwisea1/2turn,rstoneboltandthenthe
other bolt until the belt does not slip.
3. After you adjust each side the 1/2 turn, do a test to see if the belt stopped slipping. If the belt still slips, do steps 2 and
3 again.
If you turn one side more than the other, the belt will move away from that side of the treadmill and may need realignment.
NOTICE: Too much tension on the belt causes unnecessary friction and wears the belt, motor and electronics.
4. Push PAUSE/STOP twice to stop the walking belt and end the Quick Start workout.
Aligning the Walking Belt
The walking belt should be centered on your treadmill at all
times. Running style and a non-level surface can cause the
belttomoveo󰀨center.Minoradjustmentstothe2boltsatthe
rearofthetreadmillarenecessarywhenthebeltiso󰀨center.
1. Push the START button to start the walking belt.
Be sure not to touch the walking belt or step on the
power cord. Keep bystanders and children away
from the product you are servicing at all times.
2. Stand at the rear of the treadmill to see which direction
the belt moves.
3. If the belt moves to the left, turn the left belt adjustment
bolt 1/4 turn clockwise and the right belt adjustment bolt
1/4 turn counterclockwise.
If the belt moves to the right, turn the left adjustment bolt
1/4 turn counterclockwise and the right adjustment bolt
1/4 turn clockwise.
4. Monitorthepathofthebeltforapproximately2minutes.Continuetoadjusttheboltsuntilthewalkingbeltiscentered.
5. Push PAUSE/STOP twice to stop the walking belt and end the Quick Start workout.
Lubricating the Walking Belt
Yourtreadmillisequippedwithalowmaintenancedeckandbeltsystem.TheWalkingBeltispre-lubricated.Beltfriction
cana󰀨ectthefunctionandlifeofthemachine.Lubricatethebeltevery3monthsorevery25hoursofuse,whichever
comesrst.Evenifthetreadmillisnotinuse,siliconewilldissipateandthebeltwilldryout.Forthebestresults,lubricate
the deck periodically with a silicone lubricant using the following instructions:
1. Turno󰀨thepowertothemachinewiththepowerswitch.
2. Unplug the treadmill fully from the wall outlet, and remove the power cord from the machine.
6mm
6mm