Assembly & Owner's Manual

30
Add User Profile
1. From the Power-Up Mode screen, push the Schwinn Advantage
™
button and hold for 3 sec-
onds to go to User Setup Mode.
Note: If no User Profile is set up, the Console will show the Name prompt for User 1. If a User
Profiledoesexist,usetheIncrease/DecreasebuttonstoselectCreateUser2andpush
START/ENTER.
2. The Console display shows the “ENTER NAME” prompt. Push START/ENTER.
3 Enter a name for the user. Use the Increase/Decrease buttons to move through the alphabet
and blank space (found between A and Z). To set each letter, push the START/ENTER button.
Push the STOP button to go back to the previous letter.
Push and hold the START/ENTER button for 3 seconds to complete the entry and go to the
nextdataprompt.
4. The Console display shows the “AGE 30” prompt. Use the Increase/Decrease buttons to adjust
thedefaultvalue,andpushSTART/ENTERtocompletetheentryandgotothenextprompt.
5. The Console display shows the “WEIGHT 150” prompt. Use the Increase/Decrease buttons
toadjustthedefaultvalue,andpushSTART/ENTERtocompletetheentryandgotothenext
prompt.
6. The Console display shows the “GENDER MALE” prompt. Use the Increase/Decrease buttons
toadjustthedefaultvalue,andpushSTART/ENTERtocompletetheentryandgotothenext
prompt.
Note: Due to screen limitations, “FEMLE” is the abbreviation for female.
7. The Console display shows the “CREATE CUSTOM YES” prompt. Use the Increase/Decrease
buttons to move to the YES or NO option. To start setup of your Custom Workout, go to YES
and push START/ENTER.
To complete User Setup without a Custom Workout, go to the NO option and push START/
ENTER. The Console goes back to the Power-Up Mode screen.
Note: The Custom workout can be created at a later time by editing the User.
8. If you start the Custom Workout setup, the Program Display will show the left column (workout
interval) is active by flashing, with a default resistance level of 3. Use the Increase/Decrease
buttons to adjust the resistance level of the active interval. Push START/ENTER to record the
resistancelevel.Thenextcolumntotherightbecomesactive.
Note: The Console display shows the message “N of 20” during setup (N is the current interval).
Themaximumnumberofintervalsis20.