Owner's Manual

©2011
U-Brake
If the brake cable is not connected at the brake lever, slide the head of the brake cable
into the brake lever per the diagram, and thread the cable through the slot in the brake
lever so the cable end rests squarely in the adjustment barrel or cable end rests in the
recess of the brake lever. (Fig. 3.16)
Brake adjustment
Check to be sure the cable is seated in the brake lever. Loosen the cable anchor bolt
just enough to allow the cable wire to move freely. With your le hand squeeze the
caliper brake unl both brake pads contact the rim. While holding the brake closed
with your le hand, use your right hand to pull the brake cable ght (through the cable
anchor) again inspecng that the cable end is seated in the brake lever, and the barrel
adjuster of the brake. Tighten the cable anchor as much as you can by hand, and then
while sll squeezing the brake, ghten the cable anchor fully with a wrench.
ASSEMBLY
Brake cable
Brake pads
Cable end cap
Cable anchor bolt
5mm Allen bolt
Housing barrel
Spring tension nut
To tension
spring
To tension
spring
FRONT
Cable carrier
20mm
Hook cable end
Brake cable
Cable anchor
5mm Allen bolt
Straddle cable
Spring tension nut
To tension
spring
To tension
spring
REAR A
Frame housing stop
To tension
spring
Brake cable
5mm Allen bolt
Spring tension nut
To tension
spring
Cable anchor
Brake housing
Cable anchor
Frame housing stop
Brake housing
Seat
Tube
REAR B
3.23
3.24
3.25
34