Owner`s manual

36
Condition/Problem Things to Check Solution
Console shuts off (enters
sleep mode) while in use
Check electrical (wall)
outlet
Make sure unit is plugged into a functioning wall outlet.
Check connection at rear
of unit
Connection should be secure and undamaged. Replace adapter
or connection at unit if either are damaged.
Check data cable integrity All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Reset Machine Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Check magnet position
(requires shroud removal)
Magnet should be in place on pulley.
Check Speed Sensor Contact Customer Care for further
assistance.
Unit rocks/does not sit
level
Check leveler adjustment Adjust levelers until bike is level.
Check surface under unit Adjustmentmaynotbeabletocompensateforextremelyuneven
surfaces. Move bike to level area.
Pedals loose/unit difficult
to pedal
Check pedal to crank arm
connection
Pedal should be tightened securely to crank. Ensure connection
is not cross-threaded.
Checkcrankarmtoaxle
connection
Crankshouldbetightenedsecurelytoaxle.Besurecranksare
connected at
180 degrees from each other.
Clicking sound when
pedaling
Check pedal to crank arm
connection
Remove pedals and reattach.
Seat post movement Check locking pin Be sure adjustment pin is locked into one of the seat post adjust-
ment holes.
Check adjustment knob Be sure knob is securely tightened.