Service manual

Basic Troubleshooting
Problem: Brake Pads Off Center
Solution:
A. Use a 10mm wrench to loosen the nylon nut on the front of the
bike.
B. Adjust the brake assembly until the brake pads are evenly
spaced from the flywheel.
C. Tighten the nylon nut using moderate torque.
Figure 3
Figure 4
Problem: Chain is too Loose
Solution:
A. Use a 15mm wrench or socket to loosen each axle nut of the
flywheel.
B. Use a 10mm wrench and turn each chain tensioner bolt 1/4
turn to the right.
C. Get on the bike and check for any play in the chain by
rocking back and forth on the pedals.
D. Tighten the axle nuts on the flywheel once the pedals and
the flywheel are moving as one.
NOTE: Make sure that the flywheel aligns with the frame.
Service Manual
8