Schwinn® MPower™ Echelon Console + Power ©2013 Core Fitness, LLC, dba StairMaster. All rights reserved. ™ and ® indicates a trademark or registered trademark. Core Fitness, LLC trademarks include Schwinn®, A.C.™, Smart Release™, Ride Right™, MPower™, IC Pro™, QuickFit™, Triple Link™ and respective logos. 1.888.678.2476, www.stairmaster.
Introduction Welcome to the new Schwinn MPower Echelon Console! Your new console will add measurement to your Schwinn bike, giving you more training options than ever before.
Specifications MPower Echelon Console Speed Sensor Power Sensor Power Requirements 5.2” (13.3 cm) Echelon Console 1.8” (4.
Important Safety Instructions Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Before using this equipment, obey the following warnings: Read and understand the complete Owner’s Manual. Keep Owner’s Manual for future reference. Read and understand all warnings on this machine. If at any time the warning stickers become loose, unreadable or dislodged, contact Customer Service for replacement stickers.
Coaching Quadrant
A1 WATTS (Power) A5 STAGE Time and Distance A2 RPM (Cadence) A6 Heart Rate A3 KMH / MPH (Speed) A7 Gear Indicator A4 KCAL (Calories) A8 TOTAL Time and Distance Note: To change the measurement units to English Imperial or metric, refer to the User Setup section of this manual. CoachJOH Quadrant The calculated speed is based on wattage output. WATTS data only shows if there is a power sensor installed on the bike. heart icon is displayed as a solid heart.
Workout Totals The TOTAL display field shows the total time and distance for the entire workout period. Keypad The multi-function keypad lets you set the console measurements for your workout, see and update your workout data, and examine the console diagnostic messages. Tap any button to activate the console from Sleep Mode. The Operations section of this manual gives the procedures for using the buttons in each Operations mode.
Operations Sleep Mode The console automatically goes into Sleep Mode to conserve the battery: If there is no activity for 45 seconds after User Setup. After Display Results. If Workout Mode pauses and there is no activity for 5 minutes. Push any button to switch from Sleep Mode to User Setup Mode. User Setup Mode In User Setup Mode the console collects user data to calculate and record workout data. Proximity linking to the user’s HRM or Ant+ watch also occurs while in User Setup.
Display Results Mode To stop the workout and go to Display Results Mode, push the END button and hold it for 3 seconds or longer. The console shows total Calories, total time and distance, and the Max and Average values for Speed, Watts, Heart Rate and RPM. The Max values show first for 5 seconds. Tap the AVG/MAX button to change between the Max and Average values. After 1 minute, the console sets the values back to zero and goes into Sleep Mode.
IC Class Setup Note:
Maintenance Important: Replacing the Console Batteries t Unplug the cable from the back of the console t Plug the cable back into the console
Troubleshooting Condition/Problem Check Go to Service Mode menu and select Calibration. Do the calibration procedure. Ensure brake is completely up when calibrated. Make sure that the sensor is close enough to the flywheel so it can sense the magnet. Watt RPM Solution RPM Sensor Watt Ensure RPM sensor working - Watts will not be displayed if RPMs are not picked up. Moisten skin contact area on the chest strap. Ensure you lean close to the console during User Setup to get a connection.
Contacts CUSTOMER SERVICE Tel: 888-678-2476 E-mail: services@stairmaster.
