Specifications

Push the pairing button on the back of the Console,
Speed Sensor and Power Sensor (if applicable) and try
the Device Pairing procedure again.
E02
Power Sensor did not pair with Speed Sensor correctly.
(This error only occurs after Device Pairing was not
completed satisfactorily.)
Replace all batteries, and try the Device Pairing
procedure again.
Battery low on Console or Speed Sensor
Do a Battery Level check.
E03
Interference from the adjacent area Turn o any television, AM radio, microwave, or
computer within 6 feet (2 meters) of the bike, or move
the bike.
Battery low on Console or Power Sensor
Do a Battery Level check.
E04
Interference from the adjacent area Turn o any television, AM radio, microwave, or
computer within 6 feet (2 meters) of the bike, or move
the bike.
E07
Tilt Sensor Calibration was not done. Go to Service Mode menu,C- - submenu, C01 option.
Call StairMaster Customer Care.
E08
Tilt Sensor Calibration is incorrect or out of date Go to Service Mode menu, C- - submenu, C01 option.
Call StairMaster Customer Care.
E09
USB disabled due to low battery Replace Console batteries, and go to Service Mode,U- -
submenu,U02 option.
E10
No signal from Power Sensor Change the Brake position and pedal the bike for a few
seconds to turn on the Power Sensor.
E12
EEPROM error
Remove the console batteries and install them again. If
that does not work, call StairMaster Customer Care.
E13
Power Sensor is paired to the wrong Speed Sensor.
Do the Device Pairing procedure again.
E14
Console wireless module not able to transmit/receiv Replace console. Call StairMaster Customer Care.
23