OWNER’S MANUAL Schwinn Roadster ASSEMBLY Ages 2-4 years OPERATING ADJUSTMENTS MAINTENANCE WARRANTY In the interest of safety, make certain that you read and understand all information and instructions included with and pertaining to this product.
1
Rules for Children To avoid accidents, teach children good riding skills with an emphasis on safety from an early age. 1. Rider should always wear a properly fitted helmet that complies with US Consumer Product Safety Commission (CPSC) standard 16 CFR 1203 2. Continuos adult supervision required. 3. Allow only one rider. 4. Excessive weight may cause a hazardous or unstable condition 5. Do not play in driveways or the road. 6. Do not ride on busy streets. 7. Do not ride at night. 8.
A SPECIAL NOTE FOR PARENTS This toy is intended for use by small children. As a parent or guardian, you bear the responsibility of ensuring the safety of your child. To make sure this toy is used safely, a responsible adult must supervise any child playing with it. This includes allowing it to be used only where and when it is clearly safe for a small child to do so and making certain that it is in good repair and secure operating condition.
Step 1. Attach main frame to rear deck. Assemble by aligning the rear axle against the “C” shaped support at the end of the main frame, then rotate rear deck assembly so that the attachment bolt protrudes through the frame. Secure frame with washer and locknut, and insert the two flanking screws. Step 2. Position saddle on frame with carriage bolt protruding through center hole in frame. Tighten knob onto carriage bolt to lock saddle in position.
Step 3. Insert fork assembly through head tube of frame assembly. Be sure that fork is completely inserted through frame to allow approximately 22mm (7/8”) of fork steer tube to show through top of head tube. Push stem clamp onto fork steer tube. Stem clamp must fully seat onto fork steer tube. There should be no space between head tube and stem clamp. Insert handlebar into fork steer. Be sure to insert far enough to cover “Minimum Insertion” mark on handlebar.
Step 4. Inspect all wheels to be sure that they turn freely. If any wheel does not turn freely, check that fender is not rubbing on the tire. If it is, flex fender to the opposite side that it is rubbing on, until it is centered (see illustration). While holding front wheel, check that handlebar cannot be turned independently from wheel. Check that saddle carriage bolt and tightening knob are holding saddle securely. If necessary, tighten saddleadjustment knob further.
Schwinn Roadster Parts Diagram 7
Schwinn Roadster Parts List 8
LIMITED WARRANTY AND POLICY ON REPLACEMENT PROCEDURES AND RESPONSIBILITIES Your purchase includes the following warranty which is in lieu of all other express warranties. This warranty is extended only to the initial consumer purchaser. No warranty registration is required. This warranty gives you specific legal rights and you may have other rights which vary from state to state.
tricycle, ride with more than one person, or use the tricycle for stunting or jumping. This warranty does not cover ordinary wear and tear or anything you break accidentally or deliberately.