Manual

29
ToreleasetheInclineAssembly:
Do not adjust the workout angle when on the machine.
1. Grasp the Incline Adjustment Handle and push the Incline Release Button with
the palm of your hand. Be prepared to support the weight of the raised parts of the
machine.
When released, the Incline Assembly may fully disengage. Make sure that
you are able to support the weight of the raised parts of the machine safely.
Note: The Incline Handle may need to be slightly lifted to disengage the Incline Assembly.
2. Lower to the desired height.
In order to avoid possible serious injury when lowering the Rails, be careful to avoid ngers or hands being
caught or pinched.
4. Release the Incline Release Button.
5. Push down on the Pedals to be sure the Rails are secured by the Incline Assembly.
Note: Do not step onto the machine until you know the Incline Assembly is secure.
Power-Up / Idle Mode
The Console will enter Power-Up / Idle Mode if it is plugged into a power source, any button is pushed, or if it receives a
signal from the RPM sensor as a result of pedaling the machine.
Auto Shut-Off (Sleep Mode)
IftheConsoledoesnotreceiveanyinputinapproximately5minutes,itwillautomaticallyshutoff.TheLCDdisplayisoff
while in Sleep Mode.
Note: The Console does not have an On/Off switch.
Initial Setup
Duringtherstpower-up,theConsoleshouldbesetupwiththedate,timeandyourpreferredmeasurementunits.
1. Date:PushtheIncrease/Decreasebuttonstoadjustthecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttons
to change which segment is the currently active value (month / day / year).
2. Push OK to set.
3. Time:PushtheIncrease/Decreasebuttonstoadjustthecurrentlyactivevalue(ashing).PushtheLeft/Rightbuttons
to change which segment is the currently active value (hour / minute / AM or PM).
4. Push OK to set.
5. UnitsofMeasurement:PushtheIncrease/Decreasebuttonstoadjustbetween“MILES”(ImperialEnglish)or“KM”
(metric).
6. PushOKtoset.TheConsolegoesbacktothePower-Up/IdleModescreen.
Note: Toadjusttheseselections,consultthe“ConsoleSet-UpMode”section.