Owner's Manual

11
Attach the Rear Frame
Parts: rear frame, main frame
Hardware: 4 nuts, 4 square bolts, 4
washers, come attached to the
frame. Remove the nuts and
washers only.
Tools: None required.
1. Attach the rear frame to the main
frame of the tricycle. Slide the
U-shaped slot at the end of the rear
frame onto the bolts next to the chain
on the main frame. At the same time
align the L-shaped slots of the rear
frame with the bolts at the rear of the
main frame.
2. Slide a washer over the end of a bolt
and fasten a nut to the end of the bolt.
Note: Do not tighten the nuts at this
time.Thiswillbedoneafterthe
secondary chain is attached.
3. Repeat step 2 on the remaining bolts.
front
sprocket
rear frame slots
rear sprocket
main frame bolts
3
2
Side view of frame alignment
1
Rear and main frame attached
Schwinn Meridian Manual R3 0918112.indd 11 9/18/12 3:44 PM