Owner's Manual

WARNING!

Attach the Rear Wheels

Failure to properly tighten the nuts holding the wheels

onto the tricycle may result in poor riding performance,

the tire falling off and serious injury or death. Always

be sure the wheels are securely attached to the frame

before using the tricycle.

Parts: Drive wheel, non-drive wheel

Hardware: 2 plastic caps, 2 locknuts, 2 washers.

The locknuts come attached to the axle.

Remove the locknuts before you begin this

procedure.

Tools: 17 mm open and box end wrench

See the facing page for diagrams of the following steps.

1. Placethedrivewheel(withahalf-moonopening)on

the axle.

2. Place the washer on the axle.

3. Place the locknut on the axle and tighten securely.

Note:Thedrive

wheel hub has

a half-moon

opening that

matches the

half-moon axle.

4. Screw the plastic caps on each end of the axles.

5. Toattachthenon-drivewheelrepeatsteps1-4.

Note:Topreventtheaxlefromturningwhile

attaching the non-drive wheel, it is important to hold

the drive wheel while tightening the locknut on the

non-drive wheel.

Schwinn Meridian Manual R3 0918112.indd 13 9/18/12 3:44 PM