User manual

www.scillc.com |[e-mail] | We make life more comfortable
14
Remote Temperature Sensor
IMPORTANT ! The Remote Temperature Sensor must be from SCI.
Set DIP Switch configuration as shown before
1
1
Connect the temperature sensor leads to the T-T terminals
2
2
3
3
Reconnect the front half of the thermostat to the base (applies 24Vac power)
4
4
Verify that the displayed temperature responds to the remote sensor
The wire length for the remote sensor can be up to 100 feet (30 meters)
with standard thermostat cable (not less than 22 gauge)
If the distance is greater than 100 feet then the wire MUST be shielded type,
20-22 gauge, twisted pair
Installation Instructions