Instruction Manual

ManualsBrandsScienden ManualsElectrical EquipmentLED Lamp Control Systerm

Picture

Function Mark Note

The box was powered on

1、Maybe positive and negative cable connect mistake

Connect with APP successful

Important！！！ 1. Power on junction box; 2. Open App.;

3.While the App working for 5S, then you can press this

key and release. If the indicator lamp flashing, then the

app match with junctionx box sucessful, if not, repeat

3rd step.

It could be achieved permanent match after the first

match. No need to match again.

If all lamp was purchased from Scienden, then you do not

need to use this button. If the lamp was not from

Scienden, the car display in app would be showed

irregularly. Then you need to press this button.

—

Pattern

Rear

Dim

L.Arrow

Tk d

Lightbar

Match

Display

Press

Release

JunctionboxWirediagram

Status

Work

Unwork

Indicator

Flash

Indicator light

两个按键

Press and

release

Take down

L.Arrow

—

Pattern

—

Pattern

Alternate

—

Pattern

—

Pattern

Alternate

—

Pattern

—

Horn

Wail

Picrcer

Yelp

Connect pattern/Sync

Minibar

beacon1

beacon2

Light head1

Light head2

Siren

Connect pattern/Sync

Connect Lighthead1 Alternate wire

Connect pattern/Sync

Connect Beacon1 Alternate wire

Connect pattern/Sync

WA-001 User Instruction

Manual

Summary of content (3 pages)

PAGE 1
WA-001 User Instruction JunctionboxWirediagram Picture Function Mark Status Work Indicator light Indicator Unwork Flash Match Press and release Note The box was powered on 1、Maybe positive and negative cable connect mistake Connect with APP successful Important！！！ 1. Power on junction box; 2. Open App.; 3.While the App working for 5S, then you can press this key and release. If the indicator lamp flashing, then the app match with junctionx box sucessful, if not, repeat 3rd step.
PAGE 2
APPInstruction 2、Type：Lightbar\ Minibar\Beacon1\Beacon2\lighthead1\lighthead2\woke Lamp\Speaker 3、Function：Switch, Reset, Change flash pattern , Syn and Alter function 4、Control distance：Open 50m，Stable signal Description Function Set Match Dim Pattern Note Change the description for any key Press Match key, a dialogue box will pop up, it showed will you reset match bluetooth device , press Ok, then match data for app would be reset.
PAGE 3
FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.