User's Manual

1.2 Rear Panel:
Clear/Enroll Button:
Clear LED Status: Press the button for about 0.2 sec. to clear the alarm and warning LED status
(with a long beep).
The LED status also can be cleared from HyperSecureLink command.
Device Enroll: Press the button for about 3 sec. the LS-10 enters into Enroll Device State for 30
seconds. (Buzzer beeps and Green, Yellow, Red LEDs blink)
Please refer to Section 4.1.
1.3 Mounting Bracket:
LS-10 Base Unit can sit on a stand vertically or put in a wall mounting bracket as below.
Base Unit Stand Wall Mounting Bracket (option)