User's Manual

The HMI (Human Machine Interface) of the LS-30 adopts the interactive programming technique,

so that all settings and operations can be done very easily just by answering YES or NO and

following the instructions on the display to enter figures.

Using the HMI

 If the LCD shows a question mark (?), just answer by pressing the YES

or NO button.

Ex: The LCD shows Master Mode? , Press the YES button to enter into Master Mode.

 If the LCD shows the word Enter then key in proper figures followed by the Enter (D) key.

Ex: The LCD shows Seconds(0-255)

Enter:

The system asks the user to enter the figures between 0 and 255 and then press the Enter (D) key.

(If the user keys in 6 , 4, D, it means the timer is set at 64 seconds).

 For all the Check functions, use the ↑ and ↓ keys to move up and down the screen.

Reading the programming flow chart

State A State A-1 Down arrow

Select the next state

State Loop A State A-2 Sub-state of State A-2

Right arrow

State A-3 Enter into the sub-state

Note: Pressing

FUNC/ESC at any time will let you leave the current state loop.

Password

As many as 14 passwords can be set in the system, each with a max. of 8 digits.

Master Password (User1, default”0000”): The user with this password is authorized to

manage the other user passwords and user settings.

7 General User Passwords (User 2-User 8): Open to 7 general users; with any of these

passwords a user can change operation modes, and check all the system status.

2 Latchkey User Passwords (User 9-10): User 9 and User 10 are also called Latchkey Users.

The LS-30 will dial the Latchkey Number (Refer to (4-2-1) Set Telephone Number-

Latchkey Number) when these users arm or disarm the system.

Duress Code (User 11): Using this code to disarm the system, the LS-30 will dial and send a

duress signal to a CMS.

Installer Password (default”1234”): The user with this password is authorized to enter into

the Installer Mode.

2 CMS Passwords (CMS1 default “1111”, CMS2 default “2222”): Open to 2 CMS stations

for CMS parameter setting and system check.