User's Manual

Device Test: The system opens a 5-minute test window for the user to test the operation of all the

sensors (not including the Remote Controller). In this period, when the Base Unit receives any

signal from the sensors, it will only sound beeps and not trigger any alarm. When the 5 minutes are

over, the system returns to its original operation mode automatically. The system will escape from

the test mode immediately when it receives an Arm/Disarm signal.

Monitor Mode: In this mode all the trigger signals from the Burglar Sensors will be recorded in the

Event Log as trigger signals only; no alarm will be issued. The purpose of this mode is for the

recording of all activities in the protected area while in Disarm Mode. The system will escape from

the Monitor Mode immediately when it receives Arm/Disarm signal.

Set Partial ARM:

Groups 91 to 99 are nine independent protected zones and these zones can be Armed /Disarmed

individually. (Please refer to APPENDIX A-8)

Set Switch:

House Code <A-P>: (default <A>)

This code should be the same as the House Code set on the X-10 switches, user can select

from A to P.

Set Switch Auto Control: Set the X-10 switch working schedule for home automation

applications.

(please refer to the X-10 device operation instruction.)

Set Relay Auto Control: Set the working schedule for the Alarm Relay.

Entry Delay: Refer to Installer Mode (4-1) Entry Delay.

Exit Delay: Refer to Installer Mode (4-1) Exit Delay.

Set Password:

Latchkey User: User 9 and User 10 are also called Latchkey Users. The LS-30 will dial the

Latchkey Number (Refer to (4-2-1) Set Telephone Number- Latchkey Number) when

these users arm or disarm the system.

Duress Code (reserved): This code is used to notify the CMS (Central Monitoring Station) that a

situation has occurred that requires immediate assistance. When you key in this code in

an emergency condition, the system will be disarmed but a duress signal will be sent

to the CMS immediately. For a duress signal, authorities will be immediately

dispatched without contacting the home or business. This function is especially useful if

there is an intruder in the home or business and you do not want to alert him/her to the fact

that you have contacted the center already.