User's Manual

Entry Delay: (0-255 seconds, default 0 sec.)

This setting is the time between any burglar alarm triggers and when the alarm reaction procedure

starts.

When you return home and open the door, the Base Unit will issue warning beeps (if the Entry

Delay Beep = On) to remind you that the system is still in the Arm state and you should disarm the

system within this time. (Refer to the (4-3) Set Sound - Entry Delay Beep.)

AWAY Mode Entry Delay Burglar Alarm →

System status:

↑ (0-255 seconds) ↑

Burglar sensor triggered Siren goes off, dialing---

This Delay only works on the Burglar Sensor with its Delay ON/OFF setting in ON state.

(Refer to (4-4-1) Change Device Setting - Burglar Sensor - Enable State - Delay ON/OFF.)

Exit Delay: (0-255 seconds, default 0 sec.)

This setting is the time between selecting the AWAY mode and when the AWAY arm

becomes effective. During this time, the Base Unit will issue warning beeps to remind the

people still in the house to leave as soon as possible.

Disarm Exit Delay AWAY ARM effective →

System status:

↑ beep! (0-255 seconds)

Set AWAY mode

This Delay only works on the Controller with its Delay ON/OFF setting in ON state.

(Refer to (4-4-1) Change Device Setting-Controller-Enable State-Delay ON/OFF)

Inner Siren Time: 0-255 seconds (default 60 sec.)

The length of time the Inner Siren sounds when the alarm trips.

Relay Action Time: 0 second to 120 minutes (default 60 sec.)

The activation time of the Alarm Relay output (on the rear panel) when the alarm trips.

Sensor Supervise Time: 0-24 Hours (default 4 Hours)

The LS-30 is a supervised RF wireless system, meaning all the Burglar sensors send

“heartbeat” RF signals to the Base Unit at a certain time interval. If the Base Unit does not

receive the RF check signal from a certain sensor within the Sensor Supervise time, the

LS-30 will consider this sensor to be missing and issue a warning message.

This time can be set from 0 to 24 hours (0 hour means that the system will not check for the

“heartbeat” signal).

Remote Siren Time: 0 seconds to 30 minutes (default 60 sec.)

The length of time the external wireless Remote Siren sounds when the alarm trips. (The

Remote Siren is an Option.)