User's Manual

Pause Insertion

Note: Use the Pause key

to insert pauses between telephone number digits for dialing

to a PABX extension number. Each pause is equivalent to a 3-second break.

Answering status: Voice /Tone (default, Voice).

After dialing, the LS-30 needs an acknowledgement from the called party, either by voice

like “Hello” or by a DTMF key tone to ensure the call is connected successfully. With no

acknowledgement, the call will be deemed to have failed and will be redialed in the next

loop.

Dialing Sequence for Alarm Report

CMS1

→CMS2→SMS1→SMS2 →Pager→Specific alarm number→1st to 4th

Common numbers.

If there is any number that cannot be connected successfully, the auto-dialer will skip to

the next one and try again in the next loop until all the numbers have been tried 10

times or the cease dialing condition has been reached. (refer to (4-2) Set Telephone -

Set Cease Dialing Mode.)

Note: CMS1 and CMS2 are Central Monitoring Station numbers (refer to the (5) CMS Mode).

SMS1 and SMS2 are mobile phone SMS (Short Message Service) message and

only valid for the system with a GSM module.