User's Manual

(4-4) Set Device Enroll Device Controller Enroll

Burglar Sensor Enroll

Fire Sensor Enroll Zone Number

Medical Button Enroll

Special Sensor Enroll

Change Device Setting (4-4-1)

Delete Device Controller Delete

Burglar Sensor Delete

Fire Sensor Delete Zone Number

Medical Button Delete

Special Sensor Delete

Special Sensor Limit Set Enter Zone Number High Limit

Wire Sensor Assignment Select Input Low Limit

Select Type (4-4-1) Enable State

Enroll Device: The LS-30 uses smart code technology. The Base Unit identifies its sensors by their

unique IDs, so the Base Unit has to learn all the sensors’ ID codes in the initial system setup. (Each

sensor has a unique ID that is preset at the factory.)

60 seconds for Device Enroll

After initiating the Enroll Device procedure, there is a 60-second time window for

the device to transmit an RF signal to complete the code learning.

Delete Device: Remove the device from the system.

Special Sensor Limit Set: Set High/Low trigger limits for sensors like temperature sensor and

humidity sensor.

Wire Sensor Assignment: Set the parameters for the wire sensor inputs from the rear panel.

Up to three wire sensors can be assigned.

(The wire sensor input can be selected as a close or open trigger.

The Zone numbers of the wire sensors are fixed to “00-01”, “00-02” and “00-03”.)