User's Manual

Siren/Relay OFF: The Relay will not act and sirens will keep silent when there is an
alarm issued by this device.
Bell ON/OFF (default Bell OFF): (For Burglar sensor)
Bell ON: In Disarm Mode, the Base Unit will issue a doorbell chime when receiving a trigger
signal from this sensor if the Bell status is set to ON in Master Mode (refer to (3)
Master Mode - Bell Check - Door Bell.)
Bell OFF: In Disarm Mode, doorbell chime will not sound when receiving a trigger signal
from this sensor.
Suggestion: This state should be switched on for the Door Magnet sensors on the
front and back doors.
Latchkey ON/OFF (default Latchkey= OFF): (For Remote Controller)
Latchkey ON: This Remote Controller is assigned as a Latchkey Remote Controller. (refer to
(4-2-1) Set Telephone Number - Latchkey Number.)
Latchkey OFF: No latchkey number will be dialed for this controller.
Inactivity ON/OFF (default Inactivity=OFF): (For Burglar Sensor)
Inactivity ON: This Burglar Sensor is assigned as an Inactivity Sensor (no longer a Burglar
Sensor) to monitor the activity of an elderly or physically challenged person in the
protected area. If no activity has been detected during the preset Inactivity Time (refer to
(4-6) Set Misc.-Set Inactivity) an Inactivity Alarm (medical) will be issued.
Inactivity OFF: This is a normal Burglar Sensor.
Supervision ON/OFF: (Automatically set by the sensor itself)
(Refer to (4-1) Set Timer - Sensor Supervise Time.)
Supervision ON: System will check the “heartbeat” signal from this sensor.
Supervision OFF: System will not check the “heartbeat” signal from this sensor.
Type Alarm/Control (default Type=Alarm): (For Special Sensors)
To assign the Special Sensor as an Alarm Device or a Control Device.
(refer to the manual of the Special Sensor.)
Operation Low/High (default Operation=Low): (For Special Sensor)
To set the operation of switches or the Relay when the reading reaches the low limit or high
limit for the sensor that is set in Control Type.
(refer to the manual of the Special Sensor.)
Switch control: Select the switches that will be activated when this sensor is triggered.
X-10 Switch
As many as 16 X-10 switches (optional devices) can be controlled by each system.
For settings on the X-10 devices, refer to the instructions of the X-10 switch.
Note: In the Remote Controller, if you press the DISARM button in DISARM Mode,
the switches that have been assigned as active switches will be turned ON or
OFF.
30