User's Manual

Tamper Siren In Disarm On: The Siren will go off (if the Inner Siren has been enabled) if some

one detaches the Base Unit from the Mounting Bracket or triggers the Tamper Switch

(on Base Unit or sensors) in Disarm Mode.

Tamper Siren In Disarm Off: The siren will not go off when receiving the tamper signal from

sensors or from the Base Unit in Disarm Mode.

Set Remote Siren Type: Select the type of the remote siren used in the system. (reserved)

Siren/Relay Test: This test will activate the Inner Siren, close the Relay contacts and send an

Activate signal to the Remote Siren (if a remote siren is installed) immediately

regardless of the Inner Siren state.

(4-6) Set Misc. Set RF Jamming Warning

Check ROM Version

Reset To Factory Default Enter to Reconfirm

Emergency Button Assignment

Set Inactivity Inactivity ON Inactivity Time

Set Password Inactivity OFF

Set RS-232 Control

RF Jamming Warning: (default OFF) Enable or disable the RF jamming warning.

Reset To Factory Default:

All the settings in the Base Unit will be returned to factory default except recorded voice

and telephone numbers.

Emergency Button Assignment: Panic /Medical (default Panic)

Select the function of the Emergency Button as a Panic Button or a Medical Button

(with the zone number of 00-05).

Set Inactivity: ON /OFF (default OFF)

Inactivity On with time (0-72 hours):

1, Treats the Inactivity signal from the Wireless Medical Button as a Medical Alarm.

2, If no activity has been detected during this time from any Inactivity Sensor (Refer to

(4-4-1) Change Device Setting-Burglar Sensor-Enable State-Inactivity) the system

will issue the Inactivity Medical Alarm (with zone number of 00-06).

Inactivity Off: Ignore the Inactivity signal from the Wireless Medical Button.

Set Password: (default “1234”) Edit the Installer Password.

Set RS-232 Control: (default Enable)

Control Enable: The RS-232 interface is open for the user to access the system.

Control Disable: The RS-232 interface is closed.

Note: If this setting is disabled. Ethernet communication will be disabled too.