High Definition Digital Interactive Set-Top Explorer Use Guide

16
The mode keys are the four buttons arched
across the top of the remote. These buttons
are labeled AUX, VCR, TV, and CBL and
let you specify the device you want to
control when you are using the remote. For
example, to turn on your HDTV, you would
press TV and then press POWER.
Your remote control arrives from the
factory already programmed with the
following codes:
TV 0068
VCR 0095
CBL 0458
AUX 1037
These codes operate many popular brands
of electronic devices. Before you program
any new codes into your remote, you
should check to see if the remote already
controls your devices.
To test a mode key, turn on a device, press
the mode key for that device, and then
press POWER on the remote.
• If the device turns off, then the mode
key is probably programmed correctly.
You should not need to program a new
code for that mode key.
• If the device does not turn off, you
must program a new code for this mode
key.
Follow these steps to program a mode key:
1. Find the code for your brand of device
in one of the code lists in this guide.
The code lists begin on page 18.
Programming the Mode Keys
2. Make sure that the device is turned on.
3. Press SELECT and a mode key (AUX,
VCR, TV or CBL) at the same time
until the light at the top of the remote
blinks twice. For example, to set up the
TV key, press SELECT and TV at the
same time.
4. Enter the code for the device. For
example, if you have a Sony TV, enter
0 0 1 4.
5. Point the remote toward the device.
6. Press POWER, PLAY, or CH+ to test
the device.
7. Did the device operate correctly?
• If yes, this mode key is programmed
correctly. Write down these numbers
on page 7 of this guide. You’re ready
to use the same steps for the other
mode keys.
• If no, repeat these steps using a
different code.
Note: If all of the codes listed for
your brand of device fail to operate
your device properly, go to the
Finding More Codes section of this
guide for instructions.
POWER
GUIDE
MENU
E
X
I
T
A
U
X
V
C
R
C
B
L
T
V
N
S
E
T
T
I
N
G
S
Your remote control is already set up to
operate your set-top. The CBL mode key
is locked to keep you from changing this
setting accidentally. If you need to change
this setting to operate another device, you
must “unlock” the CBL mode key.
Unlocking the CBL Mode Key
1. Press the SELECT key and the CBL
key at the same time until the LED
blinks twice.
2. Press 9 9 6.
3. Press CH- to unlock the remote.
Result: You can now set up your CBL key
with a different cable code.