DVR User Manual

15
Use Power-Save Mode
To maximize the life of your DVR, you should power-down the DVR when it is
not in use. Simply press CBL and then press Power on your remote control, or
press Power on the front panel of the DVR. The Power light turns off, but
because the DVR still is plugged in, your scheduled recordings still occur.
Between 1:00 a.m. and 6:00 a.m. every day, your
DVR will automatically enter Power-Save mode.
In Power-Save mode, the set-top is powered-
down, but all scheduled recordings still occur.
When the DVR enters Power-Save mode, your
TV displays a black screen.
At approximately 1:10 a.m., the DVR displays a
5-minute warning banner, which states that the
DVR is about to enter Power-Save mode. When
the banner appears, do one of the following:
• To allow the DVR to enter Power-Save mode, do nothing when the warning
banner appears. The DVR will automatically power-down. After your DVR
powers down, you must press CBL and then press Power on your remote
control, or press Power on the front panel of your DVR to start watching TV
again.
• To stop the DVR from entering Power-Save mode, simply press any key on
your remote control when the warning banner appears.
From 1:10 a.m. through 6:00 a.m., the DVR displays the warning banner if you
do not press a key on the remote control or the front panel within 2 hours.
Attention
Your DVR will automatically enter power-save mode in 5 minutes.
Press any remote key to continue watching TV.