Remote Control User's Guide

573497 Rev B
9
Reprogramming your cable device button
Your AllTouch Remote Control is already set up to operate a Scientific-
Atlanta home terminal/HCT. If your remote control loses its code for
the home terminal/HCT, you need to reprogram your cable device
button. Follow the instructions below.
Notes:
• Not all cable functions work with older Scientific-Atlanta home
terminals.
• In the cable mode, the VOL button will not control the volume
through the home terminal/HCT unless you program it to do so.
See Volume Lock on page 14. The Volume Lock defaults to
TV mode.
The code for your brand of home terminal/HCT is 491.
1. Press and release
CBL
, then hold down
SET-UP
until
the red light blinks twice.
Note: You may need to wait a few seconds for the
red light to blink twice.
2. Enter
4
9
1
– the red light should blink twice
again. (If the red light does not blink twice, return
to step 1 and try again.)
3. Point your AllTouch Remote Control at your home
terminal/HCT and press
POWER
.
4. Did your home terminal/HCT turn off (or on)?
• If yes, you are finished setting up your home
terminal/HCT.
• If no, go to step 5.
Note: All VCR functions (
PLAY
,
FF
, etc.) also work in CBL
mode. To record a program, press
REC
twice.
5. If your home terminal/HCT did not respond, repeat steps 1
through 4.
6. If your home terminal/HCT still did not respond, contact your
service provider.
VCR
1
4
7
2
5
8
0
3
6
9
AUX
V
O
L
S
E
L
E
C
T
REW
PAUSE RECSTOP
PLAY FF
SET-UP BYPASS
MENU INFO
PPV
PREV. DAY NEXT DAY
MUTE
L
A
S
T
FAV
POWER
BAC
TV
CBL
C
H
T6057
SET-UP
CBL
GUIDE