Network Device User's Guide
Table Of Contents
- DPR300 Series Cable Modem Gateway Front Cover
- WebSTAR DPR300 Series Cable Modem Gateway User’s Guide
- Introduction
- In This Guide
- IMPORTANT RULES FOR SAFE OPERATION
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where is the Best Location for My Cable Modem Gateway?
- What are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- How Do I Troubleshoot My Internet Service Installation?
- What are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- What are the Requirements for Wireless Network Devices?
- How Do I Select and Place Wireless Network Devices?
- How Do I Install Wireless Network Devices?
- What are the Requirements for Home Phoneline Networking Devices?
- How Do I Select and Place Home Phoneline Networking Devices?
- How Do I Connect Home Phoneline Networking Devices?
- How Do I Configure the Cable Modem Gateway?
- How Do I Monitor the Cable Modem Gateway?
- Frequently Asked Questions
- Having Difficulty?
- Notices
- FCC Compliance
- For Information
WebSTAR DPR300 Series Cable Modem Gateway User’s Guide
46
Function Keys
The following function keys appear on the Setup Basic Settings – Network
Configuration page.
Key Description
Renew NAT Lease
Forces a release and renewal of your WAN IP
address
Apply
Saves the values you enter into the fields without
closing the screen
Configuring and Managing IP Addresses
Use the Basic Settings – IP Management page to configure how your system
manages and assigns IP addresses in your network.
If you are not familiar with the IP management procedures detailed in this
section, contact your cable service provider before you attempt to change any of
the cable modem gateway default IP management settings.
Click IP Management in the Basic Settings section of the Setup page to access
the Setup Basic Settings – IP Management page.
Setup Basic Settings – IP Management Page Example
The following illustration is an example of the Setup Basic Settings – IP
Management page.