User's Guide

© 2019 Scientific Games Corp. and its Subsidiaries. All rights reserved. Unauthorized Distribution Prohibited. CONFIDENTIAL
MPS Card Reader Installation Guide SY-TP009200[B] 11 March 2019
11
Instructions
Card Reader Body Installation
1 Align the three holes on the Adaptor Bezel, Figure 8 (A), of the Card Reader Body with the three standoffs,
Figure 8 (B), protruding from the Front Bezel and Rear Board Assembly.
Figure 8 Front Bezel and Rear Board Assembly Aligned with Card Reader Body
2 Secure the top standoff of the Front Bezel and Rear Board Assembly to the top of the Adaptor Bezel of the Card
Reader Body with one 4-40 Nut using a 1/4-inch nut driver.
CAUTION
Do not over-tighten the 4-40 Nut. This could warp the Front Bezel and Rear Board
Assembly and cause the Card Reader Body to sit unevenly.
Figure 9 Top of Front Bezel and Rear Board Assembly Attaching to Top of Card Reader Body
A
B
Draft Copy
11 March 2019