User's Guide

© 2019 Scientific Games Corp. and its Subsidiaries. All rights reserved. Unauthorized Distribution Prohibited. CONFIDENTIAL
MPS Card Reader Installation Guide SY-TP009200[B] 11 March 2019
13
Instructions
Body-to-Bezel Cable Installation
NOTE
Use one hand to stabilize the Card Reader Body. This will help prevent it from
bending.
1 Insert either of the 14-pin connectors, Figure 12 (A), from the Body-to-Bezel Cable into the 14-pin connector,
Figure 12 (B), at the rear of the MPS Card Reader Assembly.
Figure 12 MPS Card Reader Assembly and Body-to-Bezel Cable
2 Insert the other connector of the Body-to-Bezel Cable into the 14-pin connector, Figure 13 (A), on the Rear
Board of the MPS Card Reader Assembly.
• Gently and evenly apply pressure to the Body-to-Bezel Cable connector while inserting it to prevent the
Rear Board from bending.
Figure 13 14-pin Connector on Rear Board
A
B
A
Draft Copy
11 March 2019