User's Guide

© 2019 Scientific Games Corp. and its Subsidiaries. All rights reserved. Unauthorized Distribution Prohibited. CONFIDENTIAL
MPS Card Reader Installation Guide SY-TP009200[B] 11 March 2019
Preface 6
Compliance
 Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1 This device may not cause interference.
2 This device must accept any interference, including interference that may cause undesired operation of the
device.
NOTE
To comply with the FCC RF exposure compliance requirements, no change to the
antenna or the device is permitted. Any change to the antenna or the device could
result in the device exceeding the RF exposure requirements and void user’s
authority to operate the device.
NOTE
To comply with FCC/IC RF exposure compliance requirements, a separation
distance of at least 20 cm must be maintained between the antenna of this device
and all persons. This device must not be co-located or operating in conjunction
with any other antenna or transmitter.
IC: 24390-1494712
RF Radiation Hazard Warning
To ensure compliance with FCC and Industry Canada RF exposure requirements, this device must be installed in a
location where the antennas of the device will have a minimum distance of at least 20 cm from all persons. Using higher
gain antennas and types of antennas not certified for use with this product is not allowed. The device shall not be
co-located with another transmitter.
Installez l’appareil en veillant à conserver une distance d’au moins 20 cm entre les éléments rayonnants et les personnes. Cet
avertissement de sécurité est conforme aux limites d’exposition définies par la norme CNR-102 at relative aux fréquences
radio.
Industry Canada Notice and Marking
This device contains license-exempt transmitter(s)-receiver(s) that comply with Innovation, Science and Economic
Development Canada's license-exempt RSS(s).
Operation is subject to the following two conditions:
1 This device may not cause interference
2 This device must accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil contient des émetteur(s)-récepteur(s) exempts de licence et conformes aux Spécifications des normes
radioélectriques exempts de licence d'Innovation, Sciences et Développement économique Canada.
Son fonctionnement est sujet aux deux conditions suivantes:
1 Le dispositif ne doit pas produire de brouillage préjudiciable.
2 Ce dispositif doit acceptertout brouillage reçu, y compris un brouillag e susceptible de provoquer un fonctionnement
indésirable.
Draft Copy
11 March 2019