Specifications

SCION tC 2005 - VSE SUBWOOFER (BAZOOKA
®
)
Procedure
10. In Process Functional Test.
(a) Reconnect the vehicle’s negative battery
cable.
(1) Position the negative terminal at an angle
of 90˚ to the battery as shown.
(2) Tighten the nut with 4.1 N-m (36 lbf-in) of
torque.
(3) Be careful not to touch the positive battery
terminal.
(b) Referencing Step 4. d., reassemble the Radio
by connecting: 1) T-Harness into the back of
the Radio2) the Satellite harness (if equipped)
and 3) the radio antenna cable.
(1) Carefully insert Radio back into center IP
opening, by aligning mounting holes to the
radio bracket. Be sure the wire harness is
not pinched.
(2) Securely fasten (hand tighten) the four (4)
mounting fasteners using the 10mm socket
and #2 Philips Screwdriver. DO NOT
OVER TIGHTEN
(c) Turn ignition key to "ACC" position.
(d) Press the power button on the receiver/player
head unit. Verify the backlighting illuminates.
(e) Verify that the green led on the VSE is
illuminated, and that sound is coming out of
the driver.
NOTE: If the green light on the VSE unit is
illuminated, and there is no sound coming from
the driver –then one (or more) of the four (4)
speaker wires are disconnected.
NOTE: If the green light on the VSE unit is NOT
illuminated – then the wire harness is not
properly connected to either the radio/amplifier,
or is not properly grounded.
Page 10 of 17 pages
Issue: A 04/15/04