Installation manual

MAN-10001-REV1
Page 39 of 76
31. Using the supplied blue heat-shrink bullet connectors, connect the black wire on the gray plug to the
black wire on the SPAL fan wire and connect the wire on the gray plug to the red wire on the SPAL
fan. Crimp and heat shrink the connectors and use the supplied wire loom with electrical tape to
cover the exposed wires and zip-tie the harness out of the way. SEE FIGURE 6.44 & 6.45
FIGURE 6.44
FIGURE 6.45
32. Before installing the upper radiator hose, cut exactly 3/4” off the end of the radiator hose that
attaches to the neck on the cylinder head. SEE FIGURE 6.46
FIGURE 6.46
33. Reattach and secure the upper and lower radiator hoses.
34. Refill the radiator with coolant and PROPERLY BLEED the coolant system to remove any trapped air
in the coolant system.