Installation manual

MAN-10001-REV1
Page 43 of 76
8. Using a 4mm socket plug and thread into the bottom plug as shown and using an 8mm wrench,
secure the vacuum nipple on to the left side of the EWG. Use a tiny amount of thread sealant on the
barbed fitting and plug to insure an air-tight seal
9. Using the supplied 3/6” rubber vaccum hose, connect one end to the bottom port of the EWG and
the other end of the hose to the 90* vacuum nipple fitting on the turbocharger’s compressor cover.
Secure both ends of the hose with the supplied zip-tie. SEE FIGURE 7.9 & 7.10
FIGURE 7.10
FIGURE 7.11