Installation manual

MAN-10001-REV1
Page 46 of 76
9 - Installing Turbo Oiling System
1. Locate the oil sending unit towards the front the cylinder head—near the cylinder #1 exhaust
runner. SEE FIGURE 9.1
FIGURE 9.1
2. Unplug the wires that are connected to the sensor and using a 24mm socket, remove the sensor
from the head.
3. Apply a small amount of thread sealant to the threads of the sensor and fittings and install the
factory oil sensor to the supplied brass T fitting as shown in the picture below. When using a Teflon
tape thread sealant, make sure the tape does not get into the oil passages. SEE FIGURE 9.2
4. Install the supplied 1/8 NPT male to 1/8 BSP male hex nipple onto the cylinder head by hand
threading the 1/8 BSP male end onto the sensor hole on the cylinder head (the brass color end is the
BSP end, the nickel color end is the NPT end). Use a 7/16” wrench to tighten the fitting onto the
cylinder head.
5. Hand thread the brass T fitting onto the 1/8 NPT male hex nipple fitting and install the oil pressure
sensor onto the T fitting and use a 24mm socket to tighten. SEE FIGURE 9.3