Installation manual

MAN-10001-REV1
Page 49 of 76
10 – Modifying Stock Engine Oil Pain for Turbo Oil Return Line
1. If the turbo kit was purchased with the optional PTUNING pre-tapped oil pan then skip to step 9,
otherwise continue with the following steps.
2. Drain the oil from the vehicle then proceed to remove the OEM oil pan. Once removed, clean the
entire surface on the bottom of the engine block to ensure that the new oil pan will have a solid
mounting surface.
3. This is the location on the oil pan where the bung needs to be welded. SEE FIGURE 10.1 & 10.2
FIGURE 10.1
FIGURE 10.2
4. The bung needs to be welded ½” to the left edge of this hole on the right and 7/8” down from the
bottom edge of the gasket flange on the pan. Use a center punch to mark the center of the weld
bung (red circle). SEE FIGURES 10.3 & 10.4
FIGURE 10.3
FIGURE 10.4