Installation manual

MAN-10001-REV1
Page 50 of 76
5. Clean the stock engine oil pan with degreaser and remove old oil pan gasket sealant from the gasket
surface. Prep the front of the oil pan for welding by sanding down the black paint on the stock oil
pan. SEE FIGURE 10.5
FIGURE 10.5
6. Using a ¼” drill bit, drill an initial pilot hole on the center punch mark. Using a step drill bit, enlarge
the ¼” hole to 7/8” in diameter. De-bur the edge of the hole to remove any loose metal shavings.
FIGURE 10.6 & 10.7
FIGURE 10.6
FIGURE 10.7