Installation manual

MAN-10001-REV1
Page 51 of 76
7. Using the supplied steel -10AN male weld bung, TIG or MIG weld the bung onto the oil pan. Make
sure the full circumference of the bung is welded to the pan to prevent any possible oil leaks. SEE
FIGURE 10.8
FIGURE 10.8
8. Spray paint the raw metal surface of the pan and weld area with high temp paint after welding to
prevent rust.
9. Apply a bead of gray RTV silicone gasket sealant around the entire perimeter of the gasket surface
on the oil pan and install the oil pan onto the bottom of the engine block using the factory nuts and
bolts.
10. Attach the oil return line from the turbo to the welded bung on the oil pan. Be careful routing the
oil line so that it does not get kinked or touch the turbo downpipe. SEE FIGURE 10.9 & 10.10
FIGURE 10.9
FIGURE 10.10
11. Let the car sit overnight to allow the RTV silicone gasket sealant to cure, before filling with fresh
motor oil.