Installation manual

MAN-10001-REV1
Page 59 of 76
13 – Installing the FMIC Piping and Intake
1. Lay out the intercooler piping as picture below. There are six (6) pipes. SEE FIGURE 13.1
FIGURE 13.1
2. First you need to install the Turbosmart 50mm BOV onto the pipe that connects to the throttle
body. This pipe has a V-Band flange already welded on as well as the MAF sensor housing.
3. On the BOV, take the 4mm Hex Plug and plug the port on the right side of the “Turbosmart” logo.
Use a tiny amount of thread sealant to insure an air-tight seal. SEE FIGURE 13.2 & 13.3
FIGURE 13.2
FIGURE 13.3