Installation manual

MAN-10001-REV1
Page 62 of 76
9. Using the #1 IC pipe in FIGURE 13.1, insert the long straight end into the 90* coupler coming off of
the compressor outlet. The curved part of the #1 pipe should go over the subframe rail. Loosely
secure the provided T-Bolt clamps. SEE FIGURES 13.12 & 13.13
FIGURE 13.12
FIGURE 13.13
10. Install the shorter 90*elbow onto the end of the #1 pipe. This coupler needs to face towards the
passenger side of the vehicle. SEE FIGURE 13.14
11. Below is an out-of-car view of how the piping should be routed. This picture is as if you were facing
towards the front of the vehicle. Note the T-Bolt clamp placements. See FIGURE 13.14
FIGURE 13.14