Installation manual

MAN-10001-REV1
Page 63 of 76
12. Install the provided Vibra-Mounts to the subframe on the driver side and passenger side as pictured
below. The open end of the Vibra-Mount should be facing towards the front bumper.
SEE FIGURE 13.14A & 13.14B
FIGURE 13.14 A
Figure 13.14 B
13. Using a 10mm socket and flat head screw driver, remove this plastic piece on the driver side of the
vehicle. It will not be reused. SEE FIGURE 13.15 & 13.16
FIGURE 1.2
Figure 1.3
14. On the passenger side fender liner that runs underneath the engine bay, there is a small metal
bracket that is used to secure a small mudflap to it. This bracket will need to be modified in order
15. Picture below is the bracket that needs to be removed and modified. SEE FIGURE 13.17
16. The middle of the bracket after the “step up” needs to be removed. SEE FIGURES 13.18 & 13.19