Installation manual

MAN-10001-REV1
Page 71 of 76
14 – Installing Boost, Vacuum Lines and Breather Filter
1. Cut the vacuum hose that connects to the throttle body to the EGR solenoid in half and install the
supplied 3/8” brass reducing T-fitting in the orientation shown. SEE FIGURE 14.1 & 14.2
FIGURE 14.1
FIGURE 14.2
2. Connect the supplied 3/16”x18” long rubber vacuum hose as shown. Connect the other end of the
20” long vacuum hose to the vacuum fitting on the blow off valve. Secure all ends of the vacuum
line with the supplied plastic zip-tie. SEE FIGURE 14.3 & 14.4
FIGURE 14.3
FIGURE 14.2
3. Cut the vacuum hose that connects to the brake booster in half and install the supplied
3/8”x3/8”x1/8” T-fitting in the orientation shown. Connect the boost reference line (included in the
AEM F/IC box) to the 1/8” end of the t-fitting and secure the two 3/8” vacuum lines with the
supplied plastic zip-tie and the 1/8” line with a constant tension hose clamp (not included). SEE
FIGURE 14.4 & 14.5