Installation manual

MAN-10001-REV1
Page 72 of 76
4. Using a philip screw driver, punch a hole through the rubber grommet on the factory engine bay
wiring harness located on the passenger side firewall. Carefully route the 1/8” boost reference line
connected to the t-fitting, through the grommet and into the interior of the vehicle. This boost line
will later be connected to the MAP sensor on the AEM F/IC unit. SEE FIGURE 14.6
FIGURE 14.4
FIGURE 14.5
5. Install the supplied 5/8” crankcase vent hose and crankcase filter as shown. Secure the hose and
filter with the supplied worm clamp and plastic zip-tie. Use the supplied worm clamp to secure the
hose on the valve cover breather tube. SEE FIGURE 14.7
FIGURE 14.6
FIGURE 14.7