Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 10
3. Finish routing the Quick-Sync
Harness by routing it above the
accelerator pedal and steering
column into the driver side kick
panel. Run neatly and out of the
way. Use cable ties as necessary.
(Fig. 7-12)
4. Connect Quick-Sync Harness to
the 6x9 Umbilical Cable.
(Fig. 7-13)
e. Install 6x9 Umbilical Cable (Fig. 7-14)
1. Run the 6"x9" umbilical cable from
the kick panel area to the factory
amplifier located under the Driver
seat.
2. Unfasten white plastic carpet clips
along the threshold area and lift
carpet edge to expose cable route.
3. Run the cable under the carpet
and exit under the driver seat
through the opening used by the
factory amplifier wiring harness.