Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 11
4. Remove the factory amplifier
cover by removing the two (2)
plastic locking tabs on the
backside. (Fig. 7-15)
5. Unplug the 10-pin male connector
from the amplifier and connect to
the 10-pin female connector from
the 6x9 Umbilical cable. Note: The
factory amplifier is by-passed and
not used. (Fig. 7-16)
6. Reinstall the cover.
7. Re-attach carpet and close clips.
8. Power Wire Installation
a. Under the hood.
1. Locate the grommet for the main
factory wiring harness on the
driver side of the firewall directly
under the two (2) heater hoses.
2. Identify unused nipple and slice the
tip off to create an opening for the
power wire. (Fig. 8-1)
b. Under dash area (Driver side)
1. Lubricate power wire with silicone
spray or comparable substitute.
2. Run entire length through the
grommet. Note: Avoid
interference with accelerator and
brake pedals. (Fig. 8-2)