Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 12
3. Pull back approximately 6” of the
wire and apply a small amount of
silicone sealant on the wire to seal
the grommet opening.
4. Push back entire length. Note:
Inspect grommet from the engine
compartment and verify seal.
(Fig. 8-3)
5. Once the power wire installation is
completed under the dash area,
secure any wire slack to existing
factory wiring. Use cable tie as
necessary.
c. Under hood wiring routing.
Install supplied high-temp
corrugated split loom to cover the
power wires and insulate against
extreme temperature under the
hood. (Fig. 8-4)
1. Run power wires to the battery by
following the direction of the
factory wiring harness to the ECU.
(Fig. 8-5)
2. Continue in between the ECU and
Air Filter Box and end by the
battery. Secure using cable ties as
necessary.
d. Installation of the Fuse Holder
1. Remove the 10mm bolt from the
battery’s positive terminal and
install the ring terminal of the fuse
holder lead. Re-install the 10mm
bolt and tighten. Note: Do not
install fuses at this time!
(Fig. 8-6)