Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 13
2. Connect the power wires to the
fuse holder using the pre-installed
butt connectors. Use wire stripper
and strip 3/8" off the end of each
power wire. (Fig. 8-7)
3. Start with the ( larger ) 12 ga.
power wire by inserting it into the
Yellow butt connector. Note: Use
appropriate Crimp Tool
(Fig. 8-8) and apply heat to
activate the solder and heat shrink
insulator for the best connection
possible. (Fig. 8-9)
4. Insert 14 ga. wire into the Blue
butt connector and crimp. Note:
Use appropriate Crimp Tool
(Fig. 8-8) and apply heat to
activate the solder and heat shrink
insulator for the best connection
possible. (Fig. 8-9) Secure using
cable ties as necessary.