Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 14
9. Amplifier Assembly Installation
a. Connecting the DSP and Sub Amplifiers
(Fig. 9-1)
1. Plug the White and Gray 22-pin
connectors from the Quick-Sync
Harness into their designated
receptacles on the DSP Amplifier.
2. Plug the Black 10-pin connector
from the Quick-Sync Harness into
its designated receptacle on the
Sub Amplifier.
3. Plug the 6-pin Gray connector
from the Sub cable into its
designated receptacle on the Sub
Amplifier.
b. Mounting the Amplifier Assembly
1. Remove the outward-facing
10mm bolt used on the a/c
blower unit. (Fig. 9-2)
2. Remove the lower side-facing
12mm bolt off the black chassis
reinforcement bracket located
above the passenger side kick
panel. (Fig. 9-3)
3. Carefully insert Amplifier Assembly
through the bottom opening
underneath the glove box cavity.
(Fig. 9-4) Note: Tilt Amplifier
Assembly to the right to clear long
mounting arm and slip into the
designated mounting location.