Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 3
1. Vehicle Preparation
a. Apply parking brake.
b. Disconnect the negative (-) battery cable.
c. Prepare a protective surface to place all
vehicle components on.
2. Installation Prep for Amplifier Assembly
a. Remove the Amplifier Assembly and
bracket arm from the box. (Fig. 2-1)
b. Using a T-25 Torx bit, remove the screw
located at the bottom of the Assembly and
install the bracket arm. (Fig. 2-2)
c. Re-install the screw and tighten.
3. Initial Vehicle Disassembly
a. Remove trunk area mat and floor board.
b. Remove tire jack storage tray by removing
two (2) 10mm hex bolts located on the tray
bottom. (Fig. 3-1)
c. Remove Driver and Passenger side
Threshold Panel. Note: Disengage both
ends of the panel before pulling upward.
(Fig. 3-2)